EEA-PAM-513-A-14 Vickers
Wake Industrial LLC is not an authorized distributor of this product.
- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Vickers EEA-PAM-513-A-14 is part of the EEA-PAM Power Amplifiers series and has a nominal supply voltage of 24 VDC with a power consumption of 40 W. This amplifier provides a maximum solenoid current of 1.8 A and features a DIN 41612 F48 male edge connector. It has an overall height of 100 mm, a length of 175.24 mm, and weighs 200 grams.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The EEA-PAM-513-A-14 plug-in module is a power amplifier in the EEA-PAM Power Amplifiers series produced by Vickers. The card is designed for placement on a standardized backplane where it converts low-level command references into controlled drive signals for solenoid-based actuators used in automated machinery. Supplied electrical data such as allowable output current, monitoring scale, and connector type define how the board fits into a low-voltage control system and ensure repeatable current regulation for motion or pressure control loops.
Nominal operation is based on a supply of 24 VDC. A dedicated output stage can deliver up to 1.8 A to a proportional solenoid, while the fine-scale loop limits steady-state flow to 50 mA when lighter valves are driven. Command inputs may be voltage, accepted through a 47 kΩ path that minimizes source loading, or current, accepted through a 100 Ω path that holds compliance loss to only 5 V at full scale. The conditioned output is referenced to ground and clipped to 15 VDC, preventing amplifier saturation. Field wiring is completed through a DIN 41612 F48 male edge connector that mates with common industrial rack connectors.
Overall energy draw stays within 40 W, so cabinet power budgeting remains simple when multiple cards are installed. An internal detector trips at 19 V to shut the board down cleanly and avoid uncontrolled solenoid movement. The input stage tolerates up to 4 Vp-p of ripple without disturbing loop stability, while a built-in monitor test point follows the 1 V/A scale for quick current verification. Mechanical dimensions of 100 mm by 175.24 mm follow Eurocard guidelines, and the unit weighs only 200 g, reducing stress on card guides. High-impedance monitor outputs at 10 kΩ allow parallel diagnostic equipment without influencing circuit behavior.
Frequently Asked Questions about EEA-PAM-513-A-14:
Q: What is the nominal supply voltage required for the EEA-PAM-513-A-14?
A: The EEA-PAM-513-A-14 power amplifier has a nominal supply voltage of 24 VDC.
Q: What is the maximum solenoid current output for the EEA-PAM-513-A-14?
A: This amplifier supports a maximum solenoid current output of 1.8 A.
Q: What control output current does the EEA-PAM-513-A-14 provide?
A: The control output current for this model is rated at 50 mA.
Q: What type of edge connector is featured on the EEA-PAM-513-A-14?
A: The EEA-PAM-513-A-14 uses a DIN 41612 F48 Male edge connector for electrical interfacing.
Q: At what voltage does the undervoltage shutdown activate on the EEA-PAM-513-A-14?
A: This power amplifier has an undervoltage shutdown at 19 V, ensuring protection against low supply conditions.
