The DKC03.2-100-7-FW is an AC servo drive that is manufactured by the company Rexroth Indramat. This device is a part of the DKC series of servo drives and can be used in an Ecodrive system. It is an Ecodrive type 3 series 2 device. This drive controller can be used to create an automation solution for a wide range of applications.
While the DKC03.2-100-7-FW is much more affordable than some similarly featured devices, it does not compromise on quality. It follows Profibus standards for field bus communications. This device is compatible with many motors from Indramat, but some motors may require additional sensors to enable fully functioning diagnostic tools. In addition, the drive controller supports both single-axis and multi-axis motors.
The voltage rating for the DKC03.2-100-7-FW is 700V DC while it has a rated current of 100A. It comes with standard firmware. The optimal ambient operational temperature for this drive controller is between 5 degrees Celsius and 45 degrees Celsius, but it can run at temperatures up to 55 degrees Celsius. While handling this device, some precautions must be taken. While it is relatively easy to install this drive controller in an automation system, only qualified personnel should be allowed to operate this device. The storage temperature ranges from -35 degrees Celsius to 85 degrees Celsius. IP20 protection is included in the device, which means that it is adequately shielded from dust penetration but not against water entry. The maximum altitude for any setup this device can be installed in is 1000m.
Wake Industrial sells new surplus and reconditioned products. This website is not sanctioned
or approved by any manufacturer or tradename listed. Wake Industrial is not an authorized
distributor or representative for the listed manufacturers. Designated trademarks, brand names and brands
appearing herein are the property of their respective owners.
Copyright 2020 - Wake Industrial - All Rights Reserved