Product Description

The Bosch CSH01.1C-ET-EN1-NNN-MEM-L1-S-NN-FW is an advanced IndraDyn control section. It is supplied via 24 Volt and 0 Volt terminal connection at the power section. The connection points are equipped with spring terminals and screw terminal blocks. Spring terminals can be wired with wire ends equipped with or without ferules. Wires ends with ferrules need to be used with screw terminal blocks. The IndraDyn drive controller consists of two parts which are the power section and the control section. The control section plugs into the power section. The standard practice followed by Bosch is to supply a fully configured drive controller. In some cases, however, the control section can be delivered separately. The master communication interface on the CSH01.1C-ET-EN1-NNN-MEM-L1-S-NN-FW is Multi-Ethernet. The control section is configurable and includes a standard control panel.

Two optional modules and one safety module are installed on the device. The optional modules include an encoder HSF/RSF and encoder emulation. The emulation module allows emulation of absolute value and incremental encoder signals for further evaluation by a control unit. The signals are isolated from the circuit board. The emulation module does not require an external power supply. The safety module installed on the CSH01.1C-ET-EN1-NNN-MEM-L1-S-NN-FW is starting lock-out. The power consumption of the control section is 7.5 Watts. Power consumption of the encoder emulation module is 2 Watts. The typical AC output voltage of the encoder is 18.2 Volts. The output frequency of the encoder is 4 kilohertz. Power consumption of the encoder is 6 Watts. The encoder output current is 70 milliamps and the DC resistance of the load is 35 Ohms. Firmware for the device needs to be ordered as a separate subposition.