Q2AA05020DCS00 Sanyo Denki
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Sanyo Denki Q2AA05020DCS00 is a medium-inertia servo motor from the Q SANMOTION Servo Motors series. It has a 54mm flange size, a rated output of 200W, and uses a 200V supply voltage. This standard model features a 24V holding brake and operates at a maximum rotation speed between 4500 and 5000 min-1.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The Q2AA05020DCS00 is a servo motor produced by Sanyo Denki for the Q SANMOTION Servo Motors series. This model is intended for closed-loop motion axes in industrial automation, where it converts electrical power into precise shaft torque and speed for positioning tables, pick-and-place heads, and similar machinery. When connected to a compatible drive, the motor provides feedback-ready motion control that supports repeatable cycles and high throughput on assembly lines and process equipment. Its mechanical form and feedback interface match controller architectures commonly used in semiconductor, packaging, and inspection systems.
A continuous shaft power rating of 200 W establishes the limit for sustained loads, while the stator is wound as a 200 V motor for use with servo amplifiers in that voltage class. During acceleration, the rotor may operate from 4500 to 5000 rpm, providing sufficient speed for rapid indexing moves. The mounting interface uses a compact 54 mm square flange that aligns with compatible equipment brackets and gearheads. For vertical axes or emergency stops, a 24 V brake clamps the shaft when power is removed, maintaining its position without an external lock. These characteristics allow the motor to deliver controlled movement while fitting into compact automated machinery.
The winding insulation and grease formulation support operation from 0 to 40 °C. Performance is maintained in air with up to 90% relative humidity, allowing installation in climate-controlled factory areas without additional heaters. The rotor and stator mass provide a medium-inertia characteristic, which smooths speed regulation when the motor is coupled to moderate loads. Position data is returned through a reduced-wiring incremental encoder, and the selectable PP031, PP038, or PP062 sensor models allow the encoder resolution to be matched to system bandwidth requirements. The encoder supplies the drive with the position information needed to regulate shaft movement throughout each operating cycle.
