Q1AA13500DXP0EM Sanyo Denki
Wake Industrial LLC is not an authorized distributor of this product.
The Sanyo Denki Q1AA13500DXP0EM is a low-inertia servo motor from the Q SANMOTION Servo Motors series with a 130mm flange size and a maximum rotation speed ranging from 4500 to 5000 min-1. It operates on a 200V supply and supports temperatures from 0 to 40°C with up to 90% relative humidity. The motor is equipped with a PA035C reduced wiring absolute sensor and complies with both CE and UL standards.
Internal Product Review
The Q1AA13500DXP0EM is a low-inertia servo motor from Sanyo Denki’s Q SANMOTION series, well suited for responsive indexing and dynamic axis control. Reduced Wiring Absolute Sensor feedback with sensor model PA035C simplifies commissioning and supports accurate position retention. Maximum rotation speed of 4500 to 5000 min-1 gives this servo motor especially strong appeal for high-speed installations.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The Q1AA13500DXP0EM is a servo motor produced by Sanyo Denki within the Q SANMOTION Servo Motors series. It is intended for positioning and velocity-controlled axes in automated machinery where precise torque regulation and rapid response are required. By converting electrical energy into tightly regulated rotary motion, the unit integrates with matching drives to move packaging stations, pick-and-place heads, and semiconductor tooling. The motor supports closed-loop operation, allowing the connected drive to adjust shaft motion as operating commands and mechanical loads change.
The motor mounts on a frame with a flange diameter of 130 mm, allowing direct coupling to gearboxes or driven loads sized for this footprint. Its rotor can operate continuously across a speed range of 4500–5000 rpm, providing adequate headroom for rapid indexing without overspeeding the mechanical assembly. Because the rotor has low inertia, acceleration and deceleration commands from the drive result in shorter settling times. Power is supplied by a dedicated 200 V bus, so the design suits common three-phase factory power systems when used with a matching inverter. The permitted ambient temperature range is 0 to 40 °C, and the machine enclosure must maintain conditions within this range during operation.
For environmental resilience, the winding insulation and encoder section tolerate ambient moisture up to 90% relative humidity, provided condensation is avoided. Position feedback is generated by the compact PA035C encoder. Its Reduced Wiring Absolute Sensor format reduces the cable count while still supplying multi-turn position data to the controller. The unit complies with CE and UL requirements, supporting installation in European and North American industrial equipment when applicable system requirements are also met. The absence of an internal holding brake reduces overall mass and eliminates the need for brake-release circuitry. Static load retention must therefore be handled by drive-applied torque or external mechanical equipment when the shaft must remain stationary.
