Q1AA06040DXS70M Sanyo Denki
Wake Industrial LLC is not an authorized distributor of this product.
The Sanyo Denki Q1AA06040DXS70M is a low-inertia servo motor from the Q SANMOTION Servo Motors series, featuring a 60mm flange size and a rated output of 400W. It operates at a supply voltage of 200V and supports maximum rotation speeds from 4500 to 5000 min-1. This motor uses a reduced wiring incremental encoder and complies with CE and UL standards.
Internal Product Review
The Q1AA06040DXS70M is a low-inertia Q SANMOTION servo motor rated at 400 W. With a 200 V supply and reduced-wiring incremental encoder feedback, the motor integrates cleanly into motion systems and supports accurate response. CE and UL compliance adds confidence for OEM installations.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The Q1AA06040DXS70M is a servo motor produced by Sanyo Denki within the Q SANMOTION Servo Motors series. It is designed as an actuator for positioning tables, pick-and-place arms, and similar automation axes. The motor converts commands from 200 V amplifiers into controlled mechanical rotation for industrial machinery, supporting accurate position and speed regulation during repetitive motion cycles.
The motor delivers a continuous shaft power of 400 W, a level suited for midrange linear slides and indexing conveyors that must move loads quickly while remaining compact. A permissible operating range of 4500 to 5000 rpm allows rapid positioning cycles while keeping bearing heat within safe limits. Mounting follows a JIS square frame, and the 60 mm flange lets the unit bolt directly to compatible machinery brackets without shims. Dynamic response is enhanced by the low-inertia rotor, which reduces reflected inertia in the control loop and shortens settling time after direction changes. The motor uses a three-phase electrical connection. Its stator is wound for a 200 V supply, allowing direct use with matching SANMOTION Q amplifiers without voltage conversion.
The permitted ambient temperature range is 0 to 40 °C; operation above this range requires derating or forced cooling. The winding insulation tolerates up to 90% relative humidity when condensation is prevented, making the motor suitable for washdown enclosures with controlled air purging. Position and speed feedback are produced by a reduced-wiring incremental encoder that carries power and A-B-Z signals through a single shielded cable, reducing harness complexity. The PP031, PP038, and PP062 encoder resolution options support controller tuning for different gear ratios and motion requirements. Compliance with CE and UL requirements supports installation in European and North American control panels. Because the motor does not include a holding brake, mechanical locking or maintained drive torque is required to secure vertical loads during emergency stops.
