Product Description:

The Q1AA06040DXP42M servo motor is built by Sanyo Denki and belongs to the Q SANMOTION Servo Motors series. Designed as a component of the Q Series portfolio, it serves as a drive element for coordinated axes in assembly cells, inspection gantries, and other motion-controlled stations. By delivering commanded torque with minimal latency, the unit helps automation controllers execute accurate indexing, velocity tracking, and stop-start cycles that are common in modern manufacturing lines. Its electrical and mechanical interface dimensions align with common miniature gearboxes and belt stages, allowing rapid integration into space-constrained machinery.

The motor has a rated output of 400 W, which is sufficient for mid-sized tooling heads and small conveyors. The stator windings are optimized for a 200 V drive bus, so the motor connects directly to standard low-voltage servo amplifiers without an autotransformer. A square flange measuring 60 mm sets the mounting footprint and simplifies direct coupling to IEC 60 gear reducers. The rotor uses a low-inertia design, lowering reflected mass and improving acceleration when step commands are issued. With open ventilation, the shaft operates within a peak speed range of 4500–5000 rpm, enabling high-speed positioning while remaining within the motor’s magnetic saturation limits.

Feedback is provided by the model-specific PA035C encoder. This reduced-wiring absolute sensor reports multi-turn position over a two-cable link, reducing the amount of panel wiring required for the feedback connection. Continuous operation is supported at ambient temperatures from 0 to 40 °C and at relative humidity levels up to 90%, which are common conditions in indoor production spaces. The motor does not include a holding brake, so an external mechanical restraint is required when the unit controls a vertical load. The motor also conforms to CE and UL requirements for electrical safety in compatible servo drive systems.