PMM-CS-404E Sanyo Denki
Wake Industrial LLC is not an authorized distributor of this product.
The PMM-CS-404E by Sanyo Denki is part of the PM Drivers series and is a chassis or DIN rail mountable controller. It operates at 200-240 VAC with a rated output current of approximately 1.6 Amps and a power rating of around 200 Watts. This unit features overvoltage protection.
Internal Product Review
The PMM-CS-404E motor driver offers highly stable control for five-phase stepper motors with its 1.6 A current rating and 80°C thermal cutoff. Its photocoupler isolation enhances signal reliability. Integrated relay-based alarm output ensures prompt fault detection. A great solution for vibration-sensitive machinery.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The PMM-CS-404E is a motor driver by Sanyo Denki. It is part of the PM driver series optimized for accurate and low-vibration motion control systems. The PMM motor driver meets industrial EMC and insulation standards. Its housing includes grounding points for noise suppression and safety compliance.
The PMM-CS-404E motor driver operates on 200 to 240 VAC input voltage and 50/60 Hz frequency. Its rated current is 1.6 A suitable for mid-range motors and has a power rating of 200 Watts. The PMM motor driver supports both chassis and DIN rail mounting and has integrated protection from overvoltage, overload and undervoltage. The PMM motor driver uses internal temperature sensing to activate thermal protection at 80°C. Its output stages are configured for 5-phase bipolar stepper motor connection and its control interface accepts opto-isolated step and direction pulse signals. The PMM motor driver’s selectable input modes include 1-pulse and 2-pulse signal formats. Its input signal voltage range supports 5 V TTL logic with photocoupler isolation. The PMM motor driver accepts up to 100 kHz pulse frequency for high-speed operation and the step angle division is configurable via onboard DIP switch settings. It supports full-step, half-step and fine micro stepping resolutions. The PMM motor driver features a PD input to enable or disable motor excitation and the alarm output is provided through a relay contact rated for 24 VDC use.
The PMM-CS-404E motor driver’s front panel LEDs indicates power, pulse, phase origin and alarm status. The alarm LED is activated under fault conditions such as overheat or overload. Its internal logic circuitry is powered by an isolated switch and uses heatsink fins for natural convection cooling. The PMM motor driver has transparent protection shield cover for high-voltage terminals. It interfaces with Sanyo Denki SANMOTION F5 five-phase stepper motors.
