PMDSB1S3P11 Sanyo Denki
Wake Industrial LLC is not an authorized distributor of this product.
The PMDSB1S3P11 from Sanyo Denki's PM Drivers series features a round black actuator and is designed for panel mounting. This switch is SPST with a 1NO contact configuration, operates at a rated voltage of 250V AC, and handles a current of 3A. It complies with IEC/EN60947-5-1 standards.
Internal Product Review
The PMDSB1S3P11 Driver delivers stable performance with PWM control, CN3 feedback support, and test points for diagnostics. Its onboard zener diode ensures overvoltage protection. This driver includes high-capacity capacitors and DIP switch configuration. The PMDSB1S3P11 Driver by Sanyo Denki is engineered for reliability.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The PMDSB1S3P11 Driver is designed and constructed by Sanyo Denki. The Driver is an effective module that is professionally fabricated for Industrial Automation applications.
The PMDSB1S3P11 Driver comes with a DSW1 DIP switch which allows manual configuration of operating modes or address settings without software changes that offers flexibility for user defined parameters. It features a 3 pin CN3 connector which is used for output to the motor or for feedback signals such as Hall sensor or encoder return. The module has a pushbutton which provides manual input for reset, initialization or test sequences and is helpful for maintenance and troubleshooting without software tools. The inclusion of a 10 pin header (CN1) helps control signal inputs like PWM, direction, enable, fault or FG and it acts as the interface between the controller and the driver. The module includes resistors and capacitors that shape timing, smooth signals, reduce electrical noise and stabilize voltages across the circuit which is essential for reliable operation. It has a main power input terminal which delivers logic voltage (likely +5V) to the board circuitry. To store and filter power to stabilize voltage under load it has 2 electrolytic capacitors of 35 V and 470 µF which prevent voltage dips during sudden current demands.
The PM Drivers series module is designed to drive permanent magnet motors both brushed and brushless with appropriate control logic. It comes with a zener diode which protects the board from voltage spikes by clamping excessive voltage and adds reliability and safety to the power input section. For measuring voltage levels such as 5V and GND during development, diagnostics or repair it has test points TP1 and TP2. The availability of ceramic capacitors offers fast decoupling for high-speed ICs by filtering out noise and transient spikes close to the chip power pins.
