SS2000-PCI Kollmorgen
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
Current response time:
3 Minutes
48 Seconds
The Kollmorgen SS2000-PCI, part of the SS2000 SLO-SYN Drives series, features an analog resolution of 10 bits with a 500 Hz sample rate and supports a maximum encoder frequency of 500 kHz per channel. This drive operates with an AC current of 0.5 A, has a fuse rating of 2 A, and weighs 7.75 pounds. It measures 7.06 inches in height, 2.74 inches in width, and 3.79 inches in depth.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The SS2000-PCI is a slot-mounted motion control drive produced by Kollmorgen for the SS2000 SLO-SYN Drives series. It plugs into a PC’s PCI bus, runs positioning sequences, and supplies phase power to SLO-SYN stepper motors in pick-and-place heads, indexing tables, and small conveyors. Command generation, feedback decoding, and isolated field I/O reside on one board, which simplifies wiring in industrial automation cells. The card also provides encoder excitation and monitors limit switches for multi-axis machines.
The drive’s primary power input draws 0.5 A of alternating current, providing a modest input requirement. Its onboard converter digitizes ±10 V command inputs with 10 bits of resolution, so each discrete step represents approximately 0.02 V and allows fine velocity adjustments. Those samples are refreshed at 500 Hz, giving adequate bandwidth for typical stepper control loops while avoiding excessive bus traffic. An integral encoder interface supplies 5 VDC to differential receivers, and it accepts feedback up to 500 kHz per channel, permitting reliable position verification on high-speed microstepping axes. Optically isolated outputs have turn-on and turn-off delays of 10 µs and 75 µs, respectively, minimizing coupling between the noisy motor section and sensitive logic. A 2 A fuse protects the card from overloads.
The isolated output stage can sink or source 250 mA at field voltages as high as 25 V, allowing the board to drive relays, pneumatic valves, or brake solenoids without external amplifiers. The unit can operate at up to 95% RH under noncondensing conditions and can be installed at elevations up to 10,000 ft. These operating limits support use in humid factories and higher-altitude plants. The compact card measures 7.06 inches high, 2.74 inches wide, and 3.79 inches deep, allowing it to fit within densely wired control enclosures. The assembly weighs 7.75 lb, providing sufficient mass for reliable connector engagement without placing excessive strain on the backplane.
