SR30200-000000 Kollmorgen
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The SR30200-000000 servo drive is manufactured by Kollmorgen as part of the SP Servostar Servo Drives series. It provides a continuous power of 11 kW and a continuous current of 30 Amps RMS, with peak current of 60 Amps RMS for 2 seconds. The unit uses resolver feedback and has a 14-bit analog input resolution, and it weighs 5.2 kilograms.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The SR30200-000000 is a digital servo drive produced by Kollmorgen within the SP Servostar Servo Drives series. It converts a regulated DC bus into three-phase output for brushless servomotors used in packaging machines, gantry axes, and other precision automation tasks. By handling current regulation, feedback processing, and fault supervision in a single module, the unit simplifies cabinet design and reduces setup time.
It supplies a continuous current of 30 A RMS, allowing motors to operate at rated torque without thermal derating. For brief overloads, it can deliver up to 60 A RMS for two seconds. The continuous mechanical output is 11 kW, while the DC bus rating of 13.33 kW indicates the electrical power available before conversion losses. A current ripple frequency of 16 kHz results from a power stage driven by an 8 kHz PWM carrier, reducing audible noise and improving torque smoothness. Resolver feedback is accepted directly by the control board, and the analog command channel is enabled when a 24 V remote-enable signal is present. The built-in fault relay can switch 1 A at 24 VDC to transmit status information to a safety PLC.
The drive disconnects when the DC-link voltage rises above 430 VDC or the heat sink temperature reaches 90 °C. During normal operation, the power electronics dissipate 254 W, so forced-air panel cooling is recommended. Motion references enter through an analog port with 14-bit resolution, providing fine control over speed or torque loops. Undervoltage monitoring initiates a controlled shutdown at 255 VDC and a final trip at 125 VDC to protect against bus voltage sag. The enclosure weighs 5.2 kg, permitting dense multi-axis mounting without placing excessive load on DIN rails or backplates.
