CP310260 Kollmorgen
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Kollmorgen CP310260 is a servo drive belonging to the SP Servostar Servo Drives series. It has a continuous current rating of 10 Amps and a peak output current of 20 Arms. The drive operates on 230 VAC three-phase input and features overtemperature and overvoltage trip points at 80 degrees Celsius and 430 VDC, respectively. It weighs 2.69 kilograms.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The CP310260 is a digital AC servo drive produced by Kollmorgen for the SP Servostar Servo Drives series. It is intended to operate between the plant’s three-phase supply and a matched permanent-magnet servomotor, shaping current so motion controllers can issue exact speed, torque, and position commands. Inside a compact housing, the unit rectifies and inverts the mains power to deliver sinusoidal output. It also forwards status information to higher-level controls, making it a central drive interface in packaging, material-handling, and general automation equipment.
On the power side, the drive accepts a three-phase 230 VAC input at 12 A and is protected by a 25 A line fuse. Continuous motor current is 10 A, while short-term load surges are handled with 20 A RMS for dynamic acceleration. Pulse-width modulation runs at 8 kHz, which keeps acoustic noise and current ripple low. A soft-start circuit limits bus-charging current to 30 A to protect upstream circuit breakers. Control logic draws power from an isolated external 24 VDC source, and transistor status is reported through a fault relay rated at 1 A. Because the drive does not include an integrated EMC filter, external EMC components must be fitted where conducted emissions are regulated.
Operating limits are enforced electronically. The drive trips when the DC-link voltage rises above 430 VDC and disconnects when it falls below 90 VDC, preventing component stress or loss of regulation. Thermal monitoring disables the gate drives when the heat sink reaches 80 °C. During steady operation, the unit dissipates 132 W, so enclosure airflow or heat sinking must accommodate that thermal load. Its overall mass is 2.69 kg, allowing panel mounting without heavy brackets. The three-phase topology supplies the motor from the rectified DC bus, while the fault relay provides an external indication when a protective limit interrupts operation.
Frequently Asked Questions about CP310260:
Q: What is the continuous current rating of the CP310260 servo drive?
A: The CP310260 delivers a continuous current rating of 10 A for sustained operation.
Q: What input voltage and phase does the CP310260 require?
A: The CP310260 is designed for a 3-phase input voltage of 230 VAC.
Q: At what temperature does the CP310260 activate its overtemperature trip?
A: This servo drive trips on overtemperature at 80°C to help protect the device from damage.
Q: What is the peak output current capability of the CP310260?
A: Peak output current for the CP310260 is rated at 20 Arms, supporting short-term high load demands.
Q: What logic power source does the CP310260 require for operation?
A: The logic power source for the CP310260 is a 24 VDC external supply.
