Product Description:

The S7720C-SNF2-PM is a servo drive produced by Kollmorgen and supplied within the S700 Servo Drives series. It converts three-phase AC power into regulated output for brushless servomotors, providing the velocity and torque control needed in automated packaging machines, printing presses, and material-handling axes. Power electronics, signal processing, and safety functions are combined in a single enclosure so the drive can be installed on a cold-plate panel and linked to motion controllers through its built-in analog and digital I/O.

This model accepts mains voltages from 208...480 V, allowing connection to standard factory supplies without an autotransformer. The output stage switches at 8 kHz, which reduces motor current ripple and helps improve position accuracy. Under continuous operation, the inverter delivers 72 Arms, while short overloads up to 140 Arms accommodate rapid acceleration or tension spikes. For electrical service sizing, the front end draws up to 50 kVA, which helps determine breaker, conductor, and busbar requirements so voltage sag and nuisance trips are avoided.

An upstream AC line fuse rated at 80 A provides the first level of short-circuit protection and coordinates with internal semiconductor devices to limit let-through energy. Functional safety is handled by integrated dual-channel STO, which removes torque-producing energy without external contactors and meets stop category 0 requirements. The housing carries an IP20 ingress rating, meaning it is finger-safe but must be installed inside a cabinet for dusty or splash-prone environments. Maximum acoustic output is limited to 68 dB(A), allowing installation in operator areas without exceeding common industrial noise guidelines, while thermal management is assisted by the fan-controller expansion card and the cold-plate base handles the 24 W disabled-stage loss and supports 30 start-stop cycles per hour.