S60101 Kollmorgen
Wake Industrial LLC is not an authorized distributor of this product.
The S60101 is a servo drive produced by Kollmorgen and is part of the S600 Servo Drives series. It supports voltages from 230 to 480V and has a current rating of 1A rms. The drive measures 275 mm in height, 70 mm in width, and 265 mm in depth, with a weight of 4 kg. It features an internal brake resistor of 66 ohms with 80 W brake power and a rated installed load of 1 kVA.
Internal Product Review
The S60101 is a Kollmorgen S600 servo drive with a 1A rms current rating and 230...480V support. Internal braking performance is a strong point, with 80 W brake power and a 66 Ω internal brake resistor for controlled deceleration. A compact footprint and clean electrical performance make this unit a very capable choice for precise low-power motion control.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The S60101 is a servo drive produced by Kollmorgen for the S600 Servo Drives series. It provides closed-loop control and power conversion for brushless servo motors used in positioning, packaging, and material-handling equipment. By combining power electronics with integrated motion control, the unit regulates speed and torque while accepting feedback from standard motor encoders, providing a compact axis amplifier for multi-drive automation racks.
The drive delivers a continuous phase current of 1 A RMS to the motor terminals and accepts a 230–480 V three-phase AC mains supply. At that current, the thermal loss inside the housing reaches 30 W. Excess energy from regenerative deceleration is shunted through an internal braking resistor with a resistance of 66 Ω and a power capacity of 80 W. For loads with greater inertia, a 33 Ω external resistor can be connected to the dedicated brake terminals. The output current has a form factor of 1.01, indicating a nearly sinusoidal motor current that reduces copper heating. The drive supports inductive loads between 25 mH and 150 mH, allowing direct connection to a wide range of Kollmorgen and third-party motor windings. With the AS electrical option, the controller integrates digital I/O and fieldbus interfaces without requiring additional plug-in cards.
The rated power is 1 kVA, and the internal semiconductors produce a residual DC bus voltage drop of 5 V, which should be considered when sizing the supply transformer. The chassis has a width of 70 mm, a height of 275 mm, and a depth of 265 mm, allowing it to fit into compact control cabinets. The aluminum chassis, heat sink, and control board have a combined mass of 4 kg, permitting vertical DIN-rail mounting without additional supports. Quiescent power dissipation is 15 W, so enclosure ventilation must remove this baseline heat even when the drive is enabled but idle.
