PRD-00630000-03 Kollmorgen
Wake Industrial LLC is not an authorized distributor of this product.
The Kollmorgen PRD-00630000-03 is part of the S600 Servo Drives series and supports a voltage range of 230 to 480 volts. It features 14 digital inputs, 8 digital outputs, and uses a MiniCombicon connector with 12 pins. The drive offers optocoupler isolation for I/O and supports a maximum data cable length of 50 meters.
Internal Product Review
The PRD-00630000-03 is a Kollmorgen S600 servo drive with 14 digital inputs and 8 digital outputs. Optocoupler I/O isolation and a 10 ms maximum output response support clean signal handling and dependable machine coordination. Support for 230 to 480 V operation makes the drive a strong fit for industrial motion systems.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The PRD-00630000-03 module is produced by Kollmorgen for the S600 Servo Drives series. It acts as an I/O expansion stage that carries machine-level status and command signals to the drive, allowing coordinated positioning, speed regulation, and safety interlocks within automated cells. Through a single pluggable connector, it connects field wiring to the control electronics and simplifies cabinet layout in industrial automation. This arrangement consolidates multiple signal paths at one connection point while maintaining organized routing between field devices and the servo drive.
At the power interface, the board tolerates line potentials from 230 to 480 V, allowing the module to operate with a range of global mains standards. The module has fourteen digital inputs that register sensor states and eight digital outputs that operate contactors, indicator lamps, or interlock relays. The control microprocessor can refresh each output within 10 ms, while target-addressing cycles complete in 4 ms to provide sufficient bandwidth for mid-speed motion profiles. Functions become available after a maximum startup delay of 2 ms. The module can be placed up to 50 m from the master through a shielded data cable without timing loss. Each input requires only 7 mA of drive current, minimizing the electrical load on upstream PLC cards.
Protection and signal conditioning are handled directly on the board. A field-replaceable 4 A time-delay fuse protects the internal supply rail, and the electronics draw only 100 mA while idle. Logic commands arrive through a control rail rated at 24 V DC, which is isolated from the high-energy section by optocoupler circuitry to prevent ground loops. The sink outputs can switch loads of up to 500 mA, providing sufficient current for downstream coils and related control devices. Wiring terminates on a 12-pin MiniCombicon header that locks without tools and withstands vibration. The pluggable design also allows the field wiring to remain organized when the module is disconnected from the control assembly.
