502-03732-02 Kollmorgen
Wake Industrial LLC is not an authorized distributor of this product.
Wake Industrial LLC is not an authorized distributor of this product.
The Kollmorgen 502-03732-02 is part of the PIC900 Drives series and delivers an output power of 50 Watts with output rails of +5 V at 4.0 Amps, +15 V at 2.0 Amps, and -15 V at 0.5 Amps. The device has a depth of 213 mm, height of 305 mm, and width of 61 mm and uses a 3-terminal plug connector for input with a current of 2 Amps. It can withstand shocks up to 15 g for 11 ms with four shocks per axis.
Internal Product Review
The 502-03732-02 is a Kollmorgen PIC900 drive power supply module with 50 W output power and regulated +5 V, +15 V, and -15 V output rails. A 3-terminal plug connector and 2 A input current support straightforward integration and dependable control power delivery.
Have a part to sell?
Wake Industrial Warranty
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The 502-03732-02 is a dedicated power supply unit produced by Kollmorgen for the PIC900 Drives series. The assembly converts an external single-phase feed into multiple stabilized DC rails that support drive logic, sensor references, and analog circuitry used throughout an automation cell. Mounting this supply in the same chassis as the axis controllers reduces wiring distance, cuts panel depth, and helps ensure that every board in the stack receives the correct regulated voltage during startup and runtime.
The enclosure measures 213 mm deep, 305 mm high, and 61 mm wide, allowing it to slide into the PIC900 card frame without obstructing airflow between adjacent modules. Incoming power is presented on a 3-terminal plug connector, so line, neutral, and protective earth can be connected without tools. At full load, the supply draws 2 A, which keeps feeder fusing and cable sizing moderate while still delivering a continuous output capacity of 50 W. Internal regulation uses a switching topology that limits heat rise, and the layout keeps ripple within ranges demanded by the digital signal processors and resolver interfaces used in the drive stack.
Three regulated outputs are provided: +5 V/4.0 A for CPU and communication buses, +15 V/2.0 A for analog drivers, and -15 V/0.5 A for differential reference stages. These currents exceed the typical logic-rail demand of +5 V at 25 mA and ±15 V at 2 mA specified for each expansion board, leaving ample headroom for transient events. To withstand handling and transport, the unit is qualified for 15 g half-sine shocks lasting 11 ms, with four impacts applied on each axis; this mechanical resilience protects solder joints and magnetic components while the narrow form factor keeps mass close to the mounting rails.
