MSM100-14-602-M-0KA Kollmorgen
Wake Industrial LLC is not an authorized distributor of this product.
MPN: M.1302.6940
The Kollmorgen MSM100-14-602-M-0KA is part of the MSM Brushless Servo Motors series and features a rated speed of 6000 RPM with a torque rating of 14 in-lb. This servo motor has a shaft diameter of 14 mm, a shaft length of 30 mm, and a rated voltage of 200 V. It comes with a multi-turn high resolution feedback type and supports a radial load of 34 kg at 6000 RPM.
Internal Product Review
The MSM100-14-602-M-0KA is a Kollmorgen brushless servo motor with multi-turn high-resolution feedback and a rated speed of 6000 RPM. A no-brake configuration and keyed shaft design support clean integration in high-response motion assemblies. The 14 in-lb torque rating gives the motor a precise, well-balanced performance profile.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The MSM100-14-602-M-0KA servo motor is manufactured by Kollmorgen within the MSM Brushless Servo Motors series. Designed for integration with digital drives, the motor converts electrical power into tightly regulated rotary motion, allowing machinery builders to execute precise indexing, tensioning, or synchronized conveyor tasks in industrial automation cells. High-resolution multi-turn feedback supplies absolute position data to the controller, shortening homing cycles and providing position information when the system powers up.
The motor reaches a rated speed of 6000 rpm while operating on a bus voltage of 200 V. These operating limits establish the electrical frequency range that the drive must synthesize. Continuous output torque is rated at 14 in-lb, providing sufficient capacity for lightweight gear reductions or direct-drive couplings. At the rated speed, the shaft can tolerate a radial load of 34 kg, so belt tension or overhung pulley forces remain within the bearing capacity. The maximum permitted surface temperature is 125 °C, which must be considered when planning enclosure cooling and placing sensors near the frame. The unit has no integral brake, so stopping or holding torque must be supplied by the drive or an external mechanical lock. A machined keyway has a width of 5 mm and a depth of 3 mm, allowing positive torque transmission to hubs or couplings.
The mounting interface has a bolt-hole circle of 100 mm, enabling attachment to compatible IEC and NEMA adapter plates. The solid shaft has a diameter of 14 mm and extends 30 mm, providing adequate engagement length for rigid collars. The shaft-end threads are M5 × 0.8 mm and have an engagement depth of 12.5 mm for retaining screws or puller tools. Axial loading is limited to 0 kg, so thrust rings or helical couplings must isolate the shaft from end-push forces. A key is supplied with the motor for installation in the machined shaft keyway. Proper coupling alignment helps prevent unintended radial forces from reducing bearing service life.
