Product Description:

The BDS5A-106-01010/03011A2-030 is a servo drive from Kollmorgen’s BDS Industrial Servo Drives series. This unit accepts command words from a motion controller and regulates phase current to a connected synchronous motor, delivering precise position, speed, and torque control in automated packaging, pick-and-place, and material-handling equipment. By converting fixed-frequency mains power into a variable, feedback-regulated output, the drive serves as the electrical bridge between plant-level controllers and electromechanical actuators.

The drive provides a continuous output of 6.0 A, while transient demands are supported by a peak output of 12.0 A. At rated load, the inverter transfers 1.2 kVA to the motor terminals, and the embedded regulators increase this figure to 2.4 kVA during acceleration without exceeding component limits. The switching devices operate at 10.0 kHz, producing a fine duty cycle that lowers audible noise and smooths current waveforms. The power section receives 115 VAC and rectifies this input onto an internal bus maintained above 130 VDC. Command and diagnostic data move over an RS-422/RS-485 link. The resolver is energized at 8.5 kHz so that the drive can sample shaft position during operation.

The housing measures 280 mm in depth and 76 mm in width, while its overall height of 340 mm aligns with standard enclosure rows. Internal losses amount to 40 W, allowing cabinet fans to remove heat without auxiliary chillers. The DC bus has a ceiling of 225 VDC, providing capacity for regenerative braking energy before overvoltage protection engages. Feedback is processed by a 12-bit decoder with 4096 counts per revolution, which supports accurate position measurement. A 20.0 kHz ripple filter stabilizes the current loop during small positioning movements. These dimensions and operating characteristics should be considered when arranging ventilation, wiring clearances, and adjacent equipment inside the enclosure.