Product Description:

The AKM2G-63N-ANDNCA00 servo motor is produced by Kollmorgen as part of the AKM2G Magnetic Motors series. It converts electrical power into controlled rotary motion for indexing tables, pick-and-place axes, and similar equipment where position accuracy and dynamic speed regulation are required in industrial automation. The flange pattern follows IEC standards, so it fits common gearheads and linear stages. This operating role suits coordinated motion tasks that require repeatable starts, stops, and speed changes.

It operates reliably within an ambient temperature range of 5 to 40 °C and tolerates up to 95% relative humidity without condensation, which suits typical factory conditions. The molded connector uses a 1 htec M23 interface and carries power and feedback signals through a single coupler; its threaded collar and internal seals provide an IP65 protection rating at the mating surface that blocks dust and low-pressure water jets. Position data is delivered through the SFD3 Smart Feedback Device Gen. 3, so high-resolution digital feedback reaches the drive without additional encoders. The motor uses an IEC flange with accuracy grade N for accurate mounting on metric gearboxes and machine plates, and the standard customization code indicates that no special mechanical or electrical deviations were ordered.

Thermal monitoring uses a PT-1000 + PTC sensor set, giving the controller both linear temperature measurement and discrete over-temperature signaling. A frame size of 142 mm combined with rotor length code 3 sets the overall stack height and magnetic volume for the motor. Mechanical power is transmitted through a smooth shaft, which simplifies clamp-style couplings and avoids keyway stress. Because the unit is supplied without a holding brake, stationary load retention must be provided by the drive or by an external brake module.