Product Description:

The AKM2G-54M-ANDNCA00 is a servo motor built by Kollmorgen within the AKM2G Magnetic Motors series. It delivers commanded torque and speed for position-controlled axes in packaging machines, pick-and-place systems, and other factory automation equipment. A 114 mm frame conforms to IEC mechanical envelopes, and the standard customization code supports general machine integration.

Permitted ambient operation spans 5–40 °C, so cabinet or machine cooling must maintain motor case temperature inside this range to prevent demagnetization or insulation stress. The winding, electronics, and connector assembly tolerate up to 95% relative humidity without condensation during continuous operation, a figure that helps guide enclosure sealing on washdown lines. The single-cable interface exits through an IP65-rated housing, which blocks airborne dust and low-pressure water jets during cleaning cycles. Electrical power and feedback share a 1 htec M23 hybrid connector, simplifying harness routing while preserving signal integrity. Internal heat rise is tracked by the dual-element PT-1000 + PTC sensor chain, allowing the drive to reduce output or shut down before thermal limits are exceeded.

Closed-loop control resolution comes from the SFD3 smart feedback device, which embeds digital multi-turn position data directly into the power lead and reduces cable count. Mechanical mounting uses an IEC flange with accuracy N, so shaft concentricity and pilot tolerances remain consistent across gearheads or couplings. The stainless-steel rotor spins on a smooth shaft, which eliminates keyway stress risers in high-cycle indexers. For vertical or safety-critical axes, the motor ships without a holding brake, so an external locking device is required. A rotor length code of 4 balances peak torque against inertia for responsive moves within the AKM2G platform.