Product Description:

The AKM2G-42E-ANDNCA00 is a servo motor produced by Kollmorgen within the AKM2G Magnetic Motors series. It combines permanent-magnet technology with low-cogging windings to generate repeatable torque in closed-loop axis drives. The unit is intended for high-speed indexing tables, form-fill-seal equipment, and other motion platforms that depend on precise repositioning under changing loads. Its layout supports compact machine designs where accurate response and stable motion are needed throughout repeated production cycles.

Its compact motor frame size of 88 mm allows installation into small mechanical envelopes while still delivering the expected output power. The single-cable connection exits through a connector that is sealed to IP65, so dust ingress and low-pressure water jets do not reach the contacts. Continuous operation is specified from 5–40 °C, letting the motor share the same ambient range as common control cabinets. The motor can operate in environments up to 95% relative humidity, which supports use in humid production areas when condensation is controlled. Position feedback is supplied through the SFD3 Smart Feedback Device Gen. 3, which sends absolute position and temperature data on the same cable and reduces external wiring complexity. A smooth shaft interface mates with zero-backlash couplings and avoids fretting caused by keyways. This arrangement is useful in applications that need precise torque transfer without adding backlash at the coupling.

For flexible cabling, the power and signal leads terminate in an 1 htec M23 connector that matches compatible hybrid cable sets. Internal temperature monitoring relies on a PT-1000 + PTC sensor pair, enabling the drive to respond before thermal limits are reached. The electromagnetic section uses rotor length 2, which provides mid-range torque density while keeping inertia moderate for fast acceleration. An IEC flange with accuracy N supports direct mounting to gearheads, and the standard customization level means the motor is supplied without application-specific alterations. The design is supplied without a holding brake, so any load that must remain fixed during power-off conditions requires external mechanical holding.