Product Description:

The AKM2G-33G-ANDNCA00 servo motor is manufactured by Kollmorgen as part of the AKM2G Magnetic Motors series. It is a permanent-magnet synchronous unit intended for closed-loop motion tasks in industrial automation. By converting commanded current into torque, it positions loads in packaging lines, pick-and-place modules, and general machine tools, while its IEC flange simplifies integration with gearboxes or direct-drive assemblies. Its smart feedback channel and temperature sensors send real-time data to the drive, supporting accurate speed regulation across repetitive cycles. This makes it suitable for automated axes that require repeatable starts, stops, and holding accuracy during frequent production runs.

This model operates in ambient temperatures from 5-40 °C, so surrounding air must keep the housing within that window during operation. The combined power and feedback connector carries a protection class of IP65, which helps block dust and low-pressure water jets at the connection point. All conductors terminate on a single htec M23 plug, using a common circular interface for power and signal routing. Rotor position is read by the SFD3 Smart Feedback Device Gen. 3, which sends absolute angle and diagnostic data to compatible drives. The motor is supplied without a brake, so any holding function must come from drive torque or external hardware. It is supplied in the standard customization level, using the standard dimensions and coatings for this model.

The motor has a frame side of 72 mm, and rotor length code 3 provides a longer active stack for added torque within the same basic footprint. Continuous duty is permitted in environments up to 95% relative humidity when condensation is prevented, which supports use in enclosed production areas with demanding moisture conditions. A dual thermal chain of PT-1000 + PTC sensors reports winding temperature so the drive can reduce current before overheating develops. Power is transmitted through a smooth shaft, allowing the use of clamp couplings or interference-fit pulleys without keyway loading, and the flange is machined to IEC accuracy N for repeatable alignment with precision gear stages.