Product Description:

Kollmorgen manufactures the AKM52L-ANDNCA00 as part of the AKM Synchronous Servo Motors series. The motor belongs to the brushless AC servo family used in gantry stages, pick-and-place heads, and general motion axes to translate commanded current into regulated torque and speed. Its construction follows a standard customization level, so its mechanical, electrical, and feedback interfaces match standard series offerings for use in multi-axis systems. The frame and winding combination is intended for medium horsepower output where quick acceleration and moderate continuous duty are both required.

The motor body spans a frame dimension of 108 mm, giving a compact cross-section that allows close center distances. Mounting uses an IEC flange with accuracy N, which supports precise alignment when bolted to gearboxes or direct-drive loads. All power, signal, and optional brake conductors terminate in a single 1 i-tec Hybrid or SpeedTec Ready Hybrid connector, reducing connection complexity at the motor interface. A smooth shaft exits the rotor and is ready for clamp hubs or shrink discs where zero-backlash transmission is needed. For commutation and position calculation, an SFD3 sensor returns absolute angle data compatible with Kollmorgen AKD and S700 drives.

The feedback system uses a single-turn inductive encoder that resolves 17-bit position over one mechanical revolution without battery support. Its housing follows the size 10/15/21 pattern used across the AKM family, and signal transport employs 2 lines for differential transmission while keeping cable diameter small. The motor uses rotor length index 2, which corresponds to the mid-length core while keeping inertia low. It also uses the L winding designation, which suits drives that supply higher voltage at lower current. Because the unit is supplied without a brake, static holding must be provided by the drive or external clamps.