Product Description:

The AKM42G-AND2CA00 is a synchronous servo motor built by Kollmorgen and assigned to the AKM Synchronous Servo Motors series. This rotary actuator supplies tightly regulated torque and speed for automated dispensing heads, indexing tables, and coordinated multi-axis gantries. Within an automation cell, it converts commanded current into precise rotary motion while maintaining compact dimensions suitable for moderate power zones on a machine frame. Its housing format also suits installations where couplings, guarding, and cable routing leave limited free space around the axis. It is commonly paired with servo amplifiers that require stable low-speed control, repeatable positioning, and smooth reversal under changing loads.

The motor includes a 24 V holding brake that clamps the rotor when power is removed, so suspended or vertical axes remain fixed without external locks. Rotor length index 2 sets the electromagnetic stack that supports continuous torque, while the feedback chain relies on the SFD3 sensor set. That resolver-based device returns rotor angle as a single-turn inductive measurement, giving absolute position at power-up without batteries. The motor uses an 84 mm frame size, which aligns with common mid-range mounting patterns and helps keep inertia low for rapid acceleration. Power is transferred through a smooth shaft, which supports zero-backlash clamping couplings and avoids keyway play during bidirectional moves. This combination supports axes that must hold position at standstill and recover reference data immediately after cycling power.

The motor uses 1 i-tec Hybrid or SpeedTec Ready Hybrid connector to combine motor power, signal, and brake conductors in a single plug. Inside that connection, the feedback transmits across 2 lines, which supports the manufacturer’s digital bus and helps maintain signal quality in electrically noisy equipment. Using one connector instead of separate plugs can simplify cable routing where moving axes leave little room for wide service loops. The front face follows the IEC with accuracy N flange configuration, allowing direct mounting to standard gearboxes and linear actuators. The winding code G is paired with the standard customization level, giving thermal behavior that is compatible with most AKD drives and suited to general-purpose servo applications.