Product Description:

The AKM33E-ANCNR-00 is a permanent-magnet synchronous servo motor produced by Kollmorgen as part of the AKM Synchronous Servo Motors series. It is intended for closed-loop industrial motion where the drive must deliver finely regulated torque and speed to packaging axes, pick-and-place heads, or rotary handling stations, allowing direct coupling to the load without intermediary belts or gear stages. Its compact format also suits machinery that needs accurate acceleration, repeatable stopping, and reliable servo response in limited installation space. This type of motor is commonly used where smooth motion, rapid reversals, and stable speed control are needed under changing load conditions.

A square 70 mm flange gives the mounting face dimension, while a smooth shaft provides a clean coupling surface for compliant clamps or keyless hubs. Power and signal lines are terminated through two SpeedTec Ready connectors, allowing quick locking in tight panels. Motion is unimpeded because the motor is supplied without a brake, so stopping and holding functions must be managed by the drive or machine. The flange follows IEC with accuracy N tolerances, supporting consistent alignment on the machine frame. The connector layout also helps keep cable routing orderly when space around the motor is limited. A resolver inside the stator supplies analog sine-cosine position data to the drive throughout the speed range.

The rotor is magnetized for 2 poles, which balances torque density with electrical frequency. Position feedback uses single-turn inductive feedback, so the drive receives position data within one mechanical turn without requiring multi-turn information. Thermal and voltage characteristics match the e winding, which suits moderate current demand at typical 230 VAC bus voltages. The motor uses rotor length index 3, which increases active stack height relative to shorter versions without changing frame width. This arrangement supports stable commutation and predictable servo behavior during frequent start-stop cycles. The feedback hardware is packaged in Size 10/15/21 format, and the build follows the standard customization level.