Product Description:

The AKM32H-GCS2LB-02 servo motor is produced by Kollmorgen and belongs to the AKM Synchronous Servo Motors series. Serving as an electrically commutated actuator, it converts controlled current from a servo drive into repeatable torque and velocity, enabling precise positioning on pick-and-place heads, labeling machines, compact gantries, and other automated equipment. The motor supports closed-loop motion with minimal mechanical backlash and consistent dynamic performance across its full speed range.

It incorporates a 24 V holding brake, which mechanically locks the shaft whenever power is removed, preventing vertical loads from drifting. Position and speed feedback are generated by an EnDat 2.1 encoder that offers a base resolution of 16/32 lines per revolution; after drive interpolation, this resolution permits sub-arc-minute positioning. Because the sensing element is multi-turn and inductive, absolute position over hundreds of revolutions is retained without batteries, and the encoder remains resistant to magnetic contamination. All power, brake, and signal leads exit through a special connector arrangement, simplifying cable routing when the motor is nested in tight frames. The square stator body has a 70 mm frame dimension, allowing it to fit standardized mounting patterns while keeping mass and inertia low for high cycle rates.

The housing is machined with alternative flange variant G, which provides a metric bolt circle that matches many planetary gearboxes without extra adapters. Torque is transmitted through a shaft with a keyway, allowing direct coupling to pulleys or rigid hubs while preserving alignment during rapid acceleration. Internally, the magnetic stack follows rotor length index 2 and pairs with the H winding to balance continuous torque against temperature rise. This arrangement supports stable operating cycles under sustained process loads without requiring a larger motor frame.