Product Description:

The AKD-P01206-NACN-0000 is produced by Kollmorgen within the AKD Servo Drives series. The unit functions as a closed-loop power amplifier between a motion controller and a permanent-magnet motor, modulating voltage and current so that axes in packaging, material handling, and electronic assembly lines follow commanded profiles accurately. Because the power stage and feedback processing are handled in one housing, the controller can send motion commands without relying on a separate amplifier module. Its control electronics close the current, velocity, and position loops internally, giving deterministic response times required in high-speed machinery.

For electrical integration, the drive accepts a rated supply of 120 / 240 Vac 1~/3~, allowing single-phase or three-phase sources to be used in light industrial panels. Under continuous duty, it delivers a nominal output of 12 Arms, while the internal power stage can furnish up to 30 Arms for five-second transients to overcome inertia during acceleration. This current reserve is useful when the axis must break static friction or respond to sudden load changes. The power section has a thermal rating of 3.82 kVA, so cables and protective devices must be selected for that apparent power. Command and diagnostic data travel over the real-time bus, and the native interface is CANopen. This communication method allows supervisory controls to exchange position commands, status words, and fault information through a common network.

The drive uses the Standard USA regional configuration, which aligns connector pinouts and EMC filters with North American codes. It also uses the Position Indexer motion option, permitting internal sequence tables so the host PLC only needs to trigger move commands. Internal sequencing lets the drive handle local motion steps without requiring the controller to calculate every segment in real time. The drive has no auxiliary I/O cards installed, which keeps the housing narrow for compact panel layouts. With a mass of 2 kg, it can be mounted on a DIN rail beside other automation components.