Product Description:

The AKD-P00306-NBS3-0000 is a compact servo drive produced by Kollmorgen and included in the AKD Servo Drives series. Intended for single-axis motion loops, it converts line power into precisely metered three-phase output that commands brushless or induction motors used in pick-and-place gantries, conveyors, and automated assembly stations. The device acts as a closed-loop power stage between a motion controller and the motor feedback transducer, supplying current proportional to the demanded torque or position profile while maintaining low latency and high resolution within the axis control chain.

Its power section accepts a single-phase or three-phase supply of 120 / 240 Vac 1~/3~, allowing the same hardware to run on standard North American or global mains. Under continuous duty, the drive delivers a nominal phase current of 3 Arms, while transient events such as acceleration or disturbance rejection are supported by a peak capability of 9 Arms for five seconds. The internal bus and switching devices are rated for a continuous input power of 1.2 kVA, balancing thermal performance with cabinet space constraints. For networked control, the integrated Ethernet-based interface supports SERCOS III, enabling deterministic communication, fast cyclic setpoints, and drive-based diagnostics without additional option cards.

The remaining parameters refine how the drive is supplied and mounted. The customization code identifies the unit as the Standard USA variant, which matches connector styles and labeling common to North American installations. Its firmware and memory resources are configured for the Position Indexer version, so the drive can execute stand-alone positioning sequences through digital I/O or fieldbus telegrams without an external motion controller. No auxiliary boards are fitted, and the hardware extension field is listed as None (rev 8+), leaving the full enclosure width free for airflow in densely populated panels. The housing and heat sink weigh only 1.1 kg, simplifying manual installation and reducing load on DIN rail or back-plate mounts.