AKT-DT-2RT-000 Kollmorgen
Wake Industrial LLC is not an authorized distributor of this product.
Wake Industrial LLC is not an authorized distributor of this product.
The Kollmorgen AKT-DT-2RT-000 is a digital output module from the AKT IO Terminals series with two channels and relay outputs that are normally open. It has a current rating of 2.0 Amps, operates at a rated load voltage of 230 V AC or 30 V DC, and offers a mechanical life of 20 million cycles. The module has an IP20 protection class and a bus current consumption of 85 mA.
Internal Product Review
The AKT-DT-2RT-000 is a Kollmorgen 2-channel digital output terminal designed for relay output switching. Rated for 230 V AC / 30 V DC and 2.0 A, the terminal offers clean, dependable output control for industrial panels.
Have a part to sell?
Wake Industrial Warranty
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The AKT-DT-2RT-000 is a relay-based digital output terminal manufactured by Kollmorgen for the AKT IO Terminals series. As an Advanced Kollmorgen Terminal module, it occupies one slot on the fieldbus rail and provides two independent relay points that can drive pilot devices, indicator lamps, or low-duty contactors in automated machines. By converting controller commands into isolated contact closures, it bridges low-energy logic levels and higher-voltage field circuits commonly found in industrial automation cells. Because the outputs are relay based, the terminal is suited to simple on-off switching tasks where electrical isolation between the control side and the load circuit is required.
This module draws a control-side bus current of 85 mA, so system power budgeting must accommodate that load on the supply line. Each relay can switch a continuous load of up to 2.0 A, and the contacts are rated for a maximum of 230 V AC / 30 V DC, allowing either mains-level AC devices or low-voltage DC solenoids to be driven. The contacts are normally open (N/O), so the field circuit closes only when the controller energizes the coil. In the controller image, the terminal occupies a two-output process width, which keeps programming access straightforward. That layout fits standard output mapping used in machine control programs.
Service life considerations include an electrical endurance of 1 × 105 operations at 5 A and 30 V DC and a mechanical endurance of 2 × 107 cycles with no load applied. For very small consumers, the relays operate reliably down to a minimum load of 10 mA at 5 V DC. The housing meets IP 20, so it is intended for installation inside enclosed control panels. An internal ballast supports lamp-test strings up to 4 × 58 W, which allows the terminal to handle common signaling loads without requiring an external accessory for that function.
