Product Description:

The 02.14.230-95 motor is produced by KEB as part of the SM Synchronous Servo Motors series. It is a compact rotary actuator intended for axes that require repeatable positioning and speed control in automated machinery. When connected to a compatible servo drive, the unit converts electrical commands into mechanical rotation for indexing conveyors, small pick-and-place heads, or auxiliary packaging stations. The motor follows the IEC frame conventions used across KEB motion platforms, allowing it to fit established machine layouts when the applicable torque and inertia requirements are met.

In operation, the unit functions as a three-phase asynchronous motor with a long design, so it relies on induced rotor currents rather than permanent magnets and can tolerate brief overloads common in indexing moves. At locked rotor, the shaft sustains a stall torque of 0.38 Nm, enabling it to drive light mechanical loads directly without additional gearing. Thermal rise is moderated by separate ventilation, which channels forced air across the stator laminations instead of relying on natural convection. The unit is supplied without a brake, so any static holding force must be provided by the drive or a mechanical lock. Its IP54 enclosure protects internal components against harmful dust deposits and water splashes from any direction. These operating characteristics support controlled motion where compact size, forced cooling, and dependable low-speed torque are required.

The assembly weighs 0.74 kg, reducing the load placed on linear slides, support plates, and cantilevered mounts. The housing is prepared for foot mounting, so its base can be bolted directly to a machine bed without special brackets. Power is transmitted through a shaft with a feather key, providing positive engagement with pulleys, gears, or rigid couplings while maintaining alignment. The motor conforms to frame size 02, which combines a compact diameter with enough winding volume to produce the stated torque. Its low mass also makes the unit suitable for auxiliary axes where available installation space and supported weight are limited. Appropriate mounting fasteners and shaft couplings should be selected for the applied radial load, operating speed, and machine arrangement.