Product Description:

The 00.S4.019-0005 motor cable is produced by KEB and appears in the S4 Combivert Servo Controllers series. It serves as the physical link between an S4 drive and its connected servo motor, carrying motor power, brake supply, and thermal monitoring signals needed for axis operation. By combining power and feedback wiring in one assembly, the cable reduces the number of separate connections that must be routed between the controller and the motor. This arrangement also helps keep wiring paths more organized in control cabinets and moving machine sections.

The assembly is delivered at a fixed length of 5 m, providing a consistent reach between the controller and motor connection points. Its conductor set uses the designation 4x1.5+2x(2x0.75), which includes four 1.5 mm² power conductors and two twisted-pair signal groups with 0.75 mm² conductors for auxiliary circuits. A continuous copper braid gives the cable a shielded design, limiting electromagnetic noise from inverter switching and helping maintain signal quality near other wiring. Mains power is carried on cores marked 1/U, 2/V, 3/W, while brake voltage is routed through terminals 5/+, 6/- so the motor brake can release during commanded motion. Each power conductor has a cross-section of 1.5 mm², balancing current-carrying ability with flexible handling during installation.

Temperature monitoring lines are identified by 7/T1(+), 8/T2(-), allowing the drive to monitor motor heat without separate sensor wiring. Operation is permitted from 20°C to 80°C, which supports use in standard machine enclosures and similar industrial settings. The cable also includes a green-yellow protective earth conductor and mates with a size 1 Power Connector 4+4 plug for secure electrical connection. Compatibility with motors labeled A1-E1 confirms that the assembly matches the required pinout and insulation arrangement for smaller S4 motor combinations.