13.F4.C0G-4G00 KEB
Wake Industrial LLC is not an authorized distributor of this product.
The KEB 13.F4.C0G-4G00 is part of the F4 Combivert Frequency Inverters series and has an input phase of 3 with a maximum rated motor power of 5.5 kW. It features a nominal input current of 13.2 A, an output nominal current of 12 A, and a protection rating of IP20. The inverter weighs 10 kg and has a maximum mains fuse rating of 20 A.
Internal Product Review
The 13.F4.C0G-4G00 is a KEB F4 Combivert frequency inverter with 3-phase input and 5.5 kW rated motor power. IP20 protection and a 16 kHz operating frequency support clean cabinet integration and stable drive response. A 12 A nominal output current makes this unit a strong choice for controlled industrial motor applications.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The 13.F4.C0G-4G00 is a variable-speed AC drive manufactured by KEB within the F4 Combivert Frequency Inverters series. As a frequency inverter, it modulates the voltage and frequency supplied to an induction motor so production machines, conveyors, or pumps can run at the precise speed demanded by the control system. Integrating this drive removes mechanical throttling devices and gives programmable acceleration, deceleration, and torque limits for energy-efficient industrial automation. It also allows the motor to respond more smoothly to changing process demands than fixed-speed operation.
Electrical performance centers on a maximum rated motor power of 5.5 kW, which the unit supports when all thermal limits are observed. To support that load, the inverter draws a nominal input of 13.2 A from a three-phase supply and delivers an output line current of 12 A. With an output apparent power of 8.3 kVA, it can supply typical 400 V motors while holding a carrier frequency of 16 kHz for reduced acoustic noise. A 20 A gG mains fuse protects the upstream circuit, and the recommended 2.5 mm² line cross section helps limit cable heating. Terminal screws require 1.2 Nm of tightening torque, and the housing mass is 10 kg for cabinet mounting. These connection requirements help maintain stable electrical contact and reduce resistive losses during continuous operation.
Continuous operation dissipates 200 W as heat, so airflow must keep the heat sink below the allowable ceiling of 90 °C. The enclosure has an IP20 ingress protection rating, which blocks fingers and solid objects larger than 12.5 mm but does not provide water protection. Installation sites must match climatic category 3K3, making the drive suitable for clean, temperature-controlled switch rooms rather than outdoor areas. Motor leads may be routed up to 100 m when shielded to the stated requirement, which helps minimize conducted noise back to the inverter. Proper panel ventilation and careful cable routing also help maintain stable operation when the drive is installed near other heat-generating equipment.
