Product Description:

The 30.E5.T60-7A00 is an electromagnetic compatibility filter produced by KEB and supplied under the Combiline EMC Filters series. It is installed on the mains side of high-power inverters or servo drives to suppress conducted interference and protect adjacent equipment connected to the plant power bus. An allowable cable run of 30 m between the drive and filter preserves the specified attenuation curve.

This model handles a continuous load of 650 A, allowing it to serve multi-axis systems that draw large line currents. During normal operation, it diverts only 60 mA of leakage current to ground, keeping touch current within safety limits for permanently wired cabinets. The filter belongs to emission category C2, so it is intended for industrial networks supplied by a dedicated transformer rather than public low-voltage grids. Internal power loss is limited to 50 W, and the resulting heat must be removed by cabinet airflow without significantly affecting drive efficiency. The iron core and film capacitor stack fit within a depth of 135 mm, leaving room for rear ducting in shallow enclosures.

The rectangular body is 260 mm wide and 300 mm high below the busbar lugs, while the required clearance to the top cover reaches 390 mm. The unit weighs 21.2 kg, which should be considered when selecting appropriate lifting and mounting equipment. Connection studs use a coarse-pitch M10 thread that matches standard ring terminals on copper laminates. The mounting slots accept 12 mm bolts, and the horizontal and vertical mounting pitches are 235 mm and 240 mm, respectively, for alignment on a back-panel grid. These dimensions and the required creepage distances maintain appropriate air gaps when the assembly is anchored inside a control cabinet with a depth of 600 mm.