18.E5.T60-10F1 KEB
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
Current response time:
4 Minutes
0 Seconds
The KEB 18.E5.T60-10F1 is part of the Combiline EMC Filters series and is designed for 3-phase AC supply with a supply voltage of 400/480 V AC. It features a nominal current of 70 Amps, maximum operating voltage of 528 V, and supports a motor cable length of 10 meters. This filter has a footprint housing type H, overall size of 300 x 445 x 66 mm, and weighs 5.1 kilograms.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
KEB manufactures the 18.E5.T60-10F1 as part of its Combiline EMC Filters series. This product is a three-phase line filter placed between an inverter and the mains to limit conducted electromagnetic noise and to meet installation guidelines for sensitive industrial automation equipment. By attenuating differential and common-mode interference, it helps variable-frequency drives operate within electromagnetic compatibility limits while allowing motor cables up to 10 m to remain inside a control cabinet without additional shielding components.
The filter is dimensioned for a continuous load of 70 A, so drive systems drawing that current can be connected without exceeding thermal limits. It tolerates phase-to-phase voltages up to 528 V, which covers 480 V utility grids and permits overvoltage events common during regenerative braking. The rated supply window of 400/480 V AC matches standard low-voltage three-phase networks, and operation stays stable across the utility spectrum of 50/60 Hz ±10 %. Line and load terminals accept conductors up to 25 mm², supporting low-impedance wiring that minimizes additional inductance in high-current paths.
The design introduces only 12 mA of earth leakage, allowing residual-current devices with selective delay to stay active on the same circuit. Internal components dissipate a maximum of 15 W as heat, so enclosure ventilation can be calculated using that fixed loss figure. Physical integration is simplified by an enclosure footprint of 300 × 445 × 66 mm, and mounting holes are predrilled on a 420 × 330 mm grid for direct panel installation. With a mass of 5.1 kg, the unit can be mounted in retrofit cabinets without additional support brackets. The filter is intended for panel-mounted drive systems that require reduced conducted emissions at the mains connection.
