14.E6.T60-4100 KEB
Wake Industrial LLC is not an authorized distributor of this product.
The KEB 14.E6.T60-4100 is an EMC filter from the Combiline EMC Filters series and supports a phase count of 3 with a nominal current of 22 Amps. It features a rated voltage of 400/480 VAC, a maximum operating voltage of 550 V, and accommodates conductor cross-sections of 6 mm². The filter weighs 2.1 kg and supports a maximum motor cable length of 300 meters.
Internal Product Review
The 14.E6.T60-4100 is a KEB Combiline EMC filter designed for 3-phase systems at 400/480 VAC. Suppression class C2 and leakage current below 3 mA support clean, stable integration in drive applications. A 22 A nominal current rating makes this filter a strong choice for dependable EMC performance.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The 14.E6.T60-4100 is a three-phase EMC filter manufactured by KEB within the Combiline EMC Filters series. The device is installed between the mains supply and an inverter or servo drive to reduce conducted interference and help the connected machine meet industrial electromagnetic compatibility requirements. By providing differential-mode and common-mode suppression, it limits drive-generated noise returning to the power network. It also helps protect nearby control electronics from disturbances that can affect stable operation on shared electrical systems.
The electrical ratings show where the filter can be used. It operates on a line supply of 400/480 VAC and passes a continuous load current of 22 A. The dielectric structure withstands up to 550 V without breakdown, giving additional margin during switching events. The unit is intended for 50/60 Hz mains with a tolerance of ±10%, so it can be used on common industrial power systems. Leakage current to protective earth remains below less than 3 mA, which supports installation in systems that monitor fault current. Because it is built for a three-phase supply, the housing uses four screw terminals for the phase connections and neutral, and these terminals accept 6 mm² copper conductors through an integral neutral link.
The enclosure dimensions are 150 mm high, 60 mm wide, and 275 mm long, and the housing mounts to a back plate through 6.5 mm holes. With only 20 W of power loss at nominal load, the filter adds little heat to a sealed cabinet. Its mass of 2.1 kg supports either rail mounting or direct screw installation without making the assembly difficult to position. The design belongs to suppression class C2, and it is intended for motor cable lengths up to 300 m where reduced conducted emissions are required on longer machine runs.
