14.E4.T60-1001 KEB
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
Current response time:
5 Minutes
54 Seconds
The KEB 14.E4.T60-1001 is an EMC filter from the Combiline EMC Filters series designed for 3-phase AC input with a nominal voltage of 400/480 V AC and a nominal current of 20 Amps. It supports a maximum operating voltage of 528 V, handles up to 30 meters of motor cable, and features a power loss of 14 Watts. This filter weighs 1.5 kilograms and has dimensions of 352 mm by 132 mm by 50 mm.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
KEB manufactures the 14.E4.T60-1001 as a line-side filter in the Combiline EMC Filters series. The device connects between an adjustable-speed drive and the facility mains to attenuate differential and common-mode noise that would otherwise propagate along power conductors. By limiting radio-frequency interference, it supports compliance with industrial EMC standards and helps protect adjacent PLC, sensor, and communication hardware from voltage-borne disturbances.
The filter carries the classification C1, indicating suitability for installations that require the lowest conducted emission levels near sensitive equipment. Its housing rises only 50 mm above the mounting surface, saving vertical space in crowded control cabinets. Terminals accept a three-phase AC supply, so all three line conductors pass through the same noise-suppressing network. At full load, the leakage current to protective earth reaches 17 mA, a parameter relevant for residual-current monitoring when multiple filters share the same feeder. The enclosure depth measures 132 mm, and the overall width is 352 mm, creating a low-profile rectangle that can be fixed directly to a back panel without extra brackets. Nominal operation is intended for 400/480 V AC systems within a 50/60 Hz ±10% frequency window.
The dielectric structure withstands up to 528 V continuously, giving headroom for utility overvoltage events and overshoots from regenerative drives. Motor cables as long as 30 m can be connected downstream while maintaining the stated attenuation values. The filter carries a nominal current rating of 20 A, and internal resistive losses convert to only 14 W of heat at that load, simplifying cabinet cooling calculations. With a mass of 1.5 kg, the unit is easy to handle during installation, and 6 mm² conductors fit the input and output terminals without cable lugs.
