12.E6.T60-3000 KEB
Wake Industrial LLC is not an authorized distributor of this product.
The KEB 12.E6.T60-3000 is part of the Combiline EMC Filters series and supports three input phases with a rated current of 12 Amps. It has a rated voltage of 400 V AC, cable cross-section of 6 mm², and allows a maximum motor cable length of 100 m for C2 and 50 m for C1. The filter measures 252 mm in height, 45 mm in width, and weighs 0.9 kg.
Internal Product Review
The 12.E6.T60-3000 is a KEB Combiline EMC filter engineered for 3-phase systems at 400 V AC. Clean integration and dependable filtering performance stand out, with 12 A rated current and support for C2 motor cable lengths up to 100 m.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The 12.E6.T60-3000 electromagnetic interference filter is produced by KEB and belongs to the Combiline EMC Filters series. Placed between a drive or inverter and the supply network, the unit attenuates conducted noise so that surrounding sensors and control electronics operate within specified immunity limits. By limiting common-mode and differential-mode disturbances, the filter helps industrial automation panels meet international EMC requirements without increasing enclosure size or changing existing drive parameters.
Electrical ratings make the filter suitable for standard motor feeders. Its nominal line voltage is 400 V AC with a continuous current capability of 12 A. The design assumes a 3-phase supply and operates at 50/60 Hz ±2. For short periods, the device tolerates up to 180 % of its rated amperage, allowing drives to start high-inertia motors without overheating the filter. Recommended motor-side wiring uses 6 mm² conductors, and compliance with the C1 category is maintained when the motor cable does not exceed 50 m; the C2 category extends that limit to 100 m. These cable-length limits help reduce the amount of common-mode noise that can pass around the filter network.
Mechanical data simplify cabinet integration. The enclosure is 45 mm wide, 77 mm deep, and 252 mm high, and it weighs only 0.9 kg. Four slotted holes sized for 5.5 mm screws provide direct panel mounting without extra brackets. The unit withstands line surges up to 550 V AC for one minute each hour and dissipates no more than 8 W under full load. Touch current to ground is limited to 1.85 mA, so multiple filters can share a single protective-earth bus without exceeding leakage thresholds. The compact housing allows placement close to the drive in confined control enclosures while still supporting extended motor cable runs.
