09.E4.T60-0001 KEB
Wake Industrial LLC is not an authorized distributor of this product.
The KEB 09.E4.T60-0001 is an EMC filter from the Combiline EMC Filters series and supports single-phase input with a rated current of 20 Amps and a rated voltage of 230 Volts. It measures 264 mm in length, 90 mm in width, and 50 mm in height, with a weight of 0.9 kg. The filter features a leakage current of 12 mA and complies with the EN 55011/B EMI limit.
Internal Product Review
The 09.E4.T60-0001 is a KEB Combiline EMC filter built for 1-phase 230 V systems. The 20 A rating and EN 55011/B EMI limit make the unit a strong choice for drive installations that require dependable line-side noise suppression. Strong filtering performance across shielded motor cable runs up to 30 m adds practical value in demanding control cabinets.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The 09.E4.T60-0001 is an EMC line filter produced by KEB within the Combiline EMC Filters series. The component is installed on the supply side of a drive controller or other sensitive load to suppress radio-frequency interference and limit conducted emissions inside industrial automation panels. Its job is to block high-frequency noise traveling both into and out of the equipment, which helps nearby sensors, PLCs, and communication wiring operate without unwanted electrical interference.
The filter handles a single-phase supply, matching installations that use one line conductor and one neutral conductor. Its nominal operating window is 230 V AC, and it tolerates up to 1 × 240 V (+10%) during brief line excursions. Under those conditions, the unit can conduct 20 A continuously, which suits small and mid-range inverters. Internal impedance causes only 12 W of heat at full load, helping limit temperature rise inside the cabinet. Displacement of leakage current is held to 12 mA, which is important when residual-current devices are used on the feeder. Conducted emissions after filtering meet EN 55011/B, allowing equipment in residential or light-industrial environments to satisfy electromagnetic compatibility requirements.
The steel housing uses submount type D and has a body length of 240 mm. Its overall dimensions are 264 mm in length, 90 mm in width, and 50 mm in height, which allows it to fit into compact control cabinets. Pre-installed output conductors extend 110 mm, simplifying connection to the drive, and the filter accepts a shielded motor cable run of 30 m without reducing attenuation. Total mass is 0.9 kg, so the unit can be mounted on DIN rails or back plates without heavy supports. The compact enclosure also helps keep cable routing organized when the filter is placed close to the inverter input.
