135N1824 Danfoss
Wake Industrial LLC is not an authorized distributor of this product.
MPN: FC-280PK75T4E20H2BXCXXXSXXXXAY
The Danfoss 135N1824 is part of the VLT FC 280 Midi Drives series and provides a power rating of 0.75 kW or 1.0 HP. It features a brake chopper, coated PCB, and operates at three phase 380-480 VAC with IP20 chassis protection. This midi drive includes an integrated POWERLINK control card and an EMC Cat C3 RFI filter for 200/400V.
Internal Product Review
The 135N1824 is a Danfoss VLT FC 280 midi drive with a 0.75 kW power rating. Integrated POWERLINK control and a brake chopper support clean networked operation and dependable deceleration performance. IP20 chassis protection and a coated PCB make the drive a strong choice for enclosed industrial panels.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The 135N1824 is a variable-frequency drive produced by Danfoss as part of the VLT FC 280 Midi Drives series. The unit converts fixed-frequency three-phase power into a modulated output that allows precise speed and torque control of small- to medium-sized induction motors used on conveyors, pumps, and general machinery. By integrating the drive inside a control panel, original equipment manufacturers can reduce reliance on mechanical throttling devices and improve energy utilization across automated lines.
Electrical compatibility is provided through a three-phase, 380–480 VAC supply range, allowing the drive to connect directly to common industrial power systems without a step-down transformer. Its rated motor output is 0.75 kW, providing suitable capacity for compact motor-driven equipment under continuous load. A built-in brake chopper dissipates regenerative energy so rapid deceleration does not raise the DC-bus voltage beyond safe operating limits. Conducted emissions are limited by the factory-installed EMC Category C3 (200/400 V) filter, helping the installation comply with EN 61800-3 requirements in industrial environments. The housing has an IP20 chassis design, which supports cabinet mounting in clean indoor areas while leaving the heat sink fins exposed to the required airflow.
System integration is supported by the integrated POWERLINK control card, which allows deterministic Ethernet packets to reach the inverter without an additional communication module. Predictable communication cycles help the controller coordinate motor commands and operating data across automated equipment. For applications rated in mechanical units, the drive supports motors up to 1.0 HP. The internal logic board has a coated printed circuit board that resists airborne contaminants and condensation commonly found in factory enclosures. Parameter access is available through status LEDs and bus-based tools, while the standard language pack supports the drive interface without a physical display. The configuration omits optional mains equipment, and the Adaptation A and B slots are unused.
