Product Description:

The FC-302P2K2T5E55H1XGXXOXSXXXXAXBXCXXXXDX is an AC variable frequency drive produced by Danfoss for the VLT FC 302 Automation Drives series. Classified under the VLT AutomationDrive FC product group, the unit converts constant-frequency mains power into a modulated output that allows industrial controllers to regulate the speed of induction motors. This capability supports controlled operation on conveyors, pumps, and material-handling equipment. By varying motor frequency and voltage in response to process requirements, the drive can reduce mechanical stress during acceleration and deceleration while improving energy use under partial loads.

The drive accepts a supply between 380–500 VAC and is designed for three-phase power networks commonly found in industrial distribution panels. Its inverter section provides up to 2.2 kW of continuous electrical power, which corresponds to approximately 3.0 HP at the motor terminals. This output capacity supports moderate industrial loads without requiring a separate voltage conversion stage. A fully gasketed housing carries an IP54/Type 12 N3R rating, helping protect the internal electronics from airborne dust and water spray. The printed circuit boards are uncoated, so the drive should be installed away from corrosive atmospheres or areas with persistent chemical vapor exposure.

An integrated RFI Class A1/B (C1) filter attenuates conducted electrical noise before it reaches the mains supply. Parameters and operating information are accessed through a graphical local control panel, which provides a visual interface for status review, motor setup, and drive adjustments. Standard language support is installed for the control panel menus. The wiring plates use European metric cable entries, allowing compatible metric cable glands to secure incoming power, motor, and control wiring. The base configuration does not include specialized input and output cards, motion controllers, a brake chopper, special mains fuses, or coated circuit boards.