Product Description:

The FC-302P2K2T5E20H1BGXXXXSXXXXAXBXCXXXXDX is a variable frequency drive manufactured by Danfoss for the VLT FC 302 Automation Drives series. This inverter belongs to the VLT AutomationDrive FC product group and is intended for cabinet installation where precise motor speed regulation is required. By converting fixed-frequency mains power into an adjustable output, the unit allows PLCs and process controllers to regulate pumps, fans, conveyors, and other motor-driven equipment. Controlled acceleration and deceleration can reduce mechanical stress on connected components, while variable-speed operation can improve energy efficiency when an application does not require a motor to run continuously at full speed.

Rated at 3.0 HP, the drive supplies a continuous mechanical output of 2.2 kW for small-frame induction motors used on auxiliary equipment. The input section accepts 380 to 500 VAC and uses three-phase power, so it connects directly to standard industrial power systems within that voltage range. The normal cabinet-mount arrangement for A, B, and C frames establishes the footprint and heat-sink orientation inside the enclosure. With IP20 chassis protection, the drive guards against accidental contact with internal electrical parts while retaining the ventilation needed for cooling. Standard cable entries use metric knockouts that accommodate common cable glands and provide orderly routing for power and control wiring. Adequate clearance around the heat sink allows cabinet airflow to remove heat during continuous operation.

A factory-installed brake chopper manages regenerative energy produced during rapid motor deceleration by directing it to a suitable braking resistor. Conducted emissions are controlled by the integrated RFI Class A1/B (C1) filter, which helps limit electrical interference returned to the incoming power line. Operators access drive parameters and operating data through the graphical local control panel, supported by the standard language pack. The printed circuit boards do not have a protective coating, so the cabinet should keep the internal air dry and limit exposure to conductive dust or corrosive contaminants. The drive carries the 302 series identifier and does not include a separate mains option. Its cabinet-mounted design provides access to the control panel while keeping power terminals and internal components within the surrounding enclosure.