Product Description:

The FC-302P11KT6131G6081HXBGXXXXSXXXXAXBXCXXXXDX is an AC variable frequency drive supplied by Danfoss as part of the VLT FC 302 Automation Drives series. The unit converts fixed-frequency mains power into a modulated output voltage so induction or permanent-magnet motors can operate at controlled speeds and torque levels. In automated conveyors, pumps, and material-handling equipment, the drive allows process adjustments and energy savings without mechanical throttling. Integrated control functions support PID loops and fieldbus communication modules that link directly with PLC architectures.

The power section is rated for 11 kW, allowing it to continuously deliver that output to the motor terminals under nominal ambient conditions. In imperial units, this rating equals 15 HP. The input side requires three-phase power, so the inverter connects directly to typical 380–480 V industrial mains without a phase converter. Within the VLT AutomationDrive FC product group, the drive has no C1 filter option; an external filter is therefore necessary when category C1 emission limits must be observed. Heat sink current capability, switching-frequency selections, and motor-dependent parameter sets are calculated around this power range to keep semiconductor losses within allowable thermal limits.

The housing provides standard cable entries, allowing metric gland plates or conduit fittings to be installed without custom punching. This arrangement accommodates common industrial cable-routing methods while preserving the enclosure’s intended installation layout. A standard language pack is preloaded in the keypad, providing English and several regional languages for operation and setup. The internal type code carries the identifier 302, aligning the control board layout with products from the same generation. The interface uses familiar Danfoss parameter numbers, simplifying drive configuration and routine maintenance for automated equipment.