Product Description:

The FC-302P11KT5E21H1XXXXXXSXXXXA0BXCXXXXD0 is an AC variable frequency drive manufactured by Danfoss for the VLT FC 302 Automation Drives series. The unit converts fixed-frequency line power into a regulated output that allows control systems to modulate induction-motor speed and torque. In automated conveyors, pumps, and general machinery, the drive maintains motor efficiency and process consistency by matching motor speed to real-time load requirements. By varying output frequency and voltage together, it supports controlled acceleration, deceleration, and speed holding instead of fixed-speed motor operation. This helps connected equipment run more smoothly when process demand changes during normal machine cycles.

Rated continuous output is 11 kW, corresponding to a mechanical shaft power of 15 HP when paired with an induction motor. The input section is designed for three-phase power and accepts line voltages between 380–500 VAC, so it connects directly to common industrial supplies without a transformer. A protection level of IP21 / Type 1 allows installation inside ventilated electrical panels where limited drip and dust exposure is expected. For electromagnetic compliance, the integrated filter is classified as RFI Class A1/B (C1), which helps reduce conducted emissions toward the line supply. The enclosure style is intended for protected indoor panels rather than exposed washdown areas or heavily contaminated spaces.

The fieldbus interface is supplied through the PROFIBUS DP V1 MCA 101 A-option card, enabling cyclic command and diagnostic exchange with PLCs over a single shielded cable. When the main supply is absent, control electronics remain powered by the MCB-107 24V DC backup D-option module, so network communication and stored settings remain available during brief dropouts. This retained control power can help a supervisory controller keep visibility of the drive long enough to record status changes or manage an orderly response. Standard cable entries accommodate shield glands, and the unit is supplied with no board coating for clean control-room and cabinet installations. Shield terminations can be kept close to the cable entry point, which helps manage electrical noise on the communication and motor leads.