Product Description:

The FC-302P11KT5E20H1XXXXXXSXXXXAYBXCXXXXDX is an AC variable frequency drive manufactured by Danfoss for the VLT FC 302 Automation Drives series. Installed between the line supply and a three-phase motor, the controller converts fixed-frequency input power into a variable-frequency output that regulates motor speed and torque. This control supports applications such as fans, pumps, conveyors, and other automated equipment while reducing mechanical stress caused by abrupt speed changes. The drive can also exchange operating commands and status information with a PLC-based control system.

The drive provides a continuous output of 11 kW, which corresponds to 15 HP of motor capacity. It accepts an input voltage range of 380–500 VAC through a three-phase power network. The unit is intended for installation in a standard control cabinet and supports the normal cabinet-mounted A, B, and C frame arrangements. Its IP20 chassis protection prevents accidental contact with internal components, but the enclosure must remain protected from direct dust, moisture, and liquid exposure. Incoming power and motor conductors enter through standard cable glands, allowing the wiring to be routed through the cabinet according to the installation layout. The power section does not include a brake chopper, so applications requiring dynamic braking must use a suitable external arrangement. A standard language pack is preloaded for remote parameter access. Because the drive has no local control panel, operating values and parameters must be accessed through another compatible interface.

The A-option slot contains a Powerlink MCA 123 module that provides deterministic Ethernet communication for coordinated automation tasks. This interface allows cyclic command and status data to move between the drive and a compatible higher-level controller. Input-side electromagnetic interference is reduced by an RFI Class A1/B (C1) filter connected to the power terminals. The filter helps limit conducted electrical noise that could otherwise affect nearby equipment or the shared supply network. The drive uses uncoated circuit boards, so installation conditions should prevent moisture and airborne contaminants from reaching the electronics. Board surfaces remain accessible for component-level soldering when authorized service procedures permit such work. The controller uses the Series Identifier 302 and belongs to the broader VLT AutomationDrive FC product group, providing a familiar parameter structure for compatible automation systems.