131B0149

Product Description:

The 131B0149 drive from Danfoss comes from the VLT FC 302 Automation Drives family, built for flexible industrial tasks where sturdy power is needed all day long. Holding steady with a 3 kW (4 HP) power output and running on a 3-phase system, this drive does just what’s needed for fans, pumps, and a whole list of automation jobs. The voltage range stretches across 380–500 V AC, and the overall size matches up well for panels that aren’t overflowing with space.

Heat usually isn’t a big problem here since the setup uses an IP20 (Chassis) enclosure, letting air move and keeping dirt away from important parts. Safety checks off a box too — an output current of 7.5 A runs non-stop when needed and matches most small- to mid-sized production lines. If the load spikes, intermittent overload current hits 12 A for short times, which comes in handy for startup surges. The internal electronics are tuned for efficiency at 0.98, so waste stays low on busy shifts, making the drive run cooler and not raise the bill as it works along.

Not a lot of rewiring or complex choices are necessary during installs. A 50/60 Hz frequency support means different locations or changes in equipment rarely slow things down. The chassis fits a bunch of common control setups, thanks to enclosure size B3 and user-proof cable tightening at 10 Nm (89 in-lb), which keeps things secure even with motors in motion. In messy spaces or workshops, protection isn’t worried about water sprays, but for dry, controlled rooms and steady automation, this drive keeps position in the panel and pulls its weight job after job. With everything inside built for lasting work, this piece just fits right into regular industrial plans and keeps moving at the same reliable rhythm.