131B0045

Product Description:

The 131B0045 drive from Danfoss is lined up in the VLT FC 302 Automation Drives series and fits in with jobs calling for control over smaller motors. Power comes in at 0.75 kW (1.0 HP), landing just right for steady movement on lighter conveyors or as a backup in a mixed drive panel. Mains voltage swings in the 380–500 VAC range, set up for three-phase hook-ups that factories often have. The IP20 chassis enclosure keeps the main bits covered but leaves air space for cooling if packed into cabinets. Height checks off at 268 mm, with a chunk of the width at 90 mm, and a footprint running 205 mm deep, so no major surprises on the install.

The interface is handled by a graphical Local Control Panel (LCP), letting workers change speeds or setups without hunting a handbook. Because of the built-in brake chopper, the drive can stop quick when needed, making it fit right in place in lines that switch off or change load often. RF interference isn’t left to chance; the Class A1/B (C1) RFI filter guards against electric noise, which cuts down headaches with sensors nearby. There’s no extra layer of dust or splash defense here, but the shape and finish keep the internals clean if a shop floor has the usual background dust. Wiring is easy with clear access and short runs from the terminals to the mains.

With the amount of power and the way it mounts, this model lines up best for jobs where it serves as a controller for small pumps, machine spindles, or simple process lines. The A2 frame size, <*not even the biggest or smallest*>, balances space with the hardware inside. No PCB coating so nothing fancy there, but for indoor, sheltered controls, it holds up well for the long term.