FC-202PK75T6131G5116 Danfoss
Wake Industrial LLC is not an authorized distributor of this product.
The Danfoss FC-202PK75T6131G5116 is a VLT FC 202 AQUA Drives series unit with a power rating of 0.75 kW and delivers 1.0 horsepower. This three phase drive operates at an efficiency of 0.97 and provides a continuous output current of 1.8 A at 525 to 550 V. It features analog output with an 8-bit resolution and digital output supporting frequencies up to 32 kHz.
Internal Product Review
The FC-202PK75T6131G5116 is a Danfoss VLT FC 202 AQUA drive with a 0.75 kW rating for three-phase power. Technical performance is strong, with 0/4-20 mA analog output support and 0.97 efficiency for stable control and economical operation. A well-tuned low-power drive, the 1.0 HP capacity makes the unit a solid fit for compact pump and water-handling systems.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The FC-202PK75T6131G5116 is a variable-frequency controller produced by Danfoss for the VLT FC 202 AQUA Drives series. It regulates centrifugal pumps and fans in industrial automation systems, matching motor speed to real-time water or wastewater demand. This control helps keep flow, pressure, and energy consumption within the required operating limits. The 202 series identifier indicates compatibility with the functions and mechanical dimensions associated with this drive series.
This three-phase unit delivers a motor shaft output of 0.75 kW, equivalent to 1.0 HP, and its internal converter maintains a continuous apparent power of 1.7 kVA at 550 V. Under typical operating conditions, the inverter supplies a continuous current of 1.8 A while drawing no more than 1.7 A from the mains. Electrical efficiency reaches 0.97, indicating that approximately 3% of the input power is lost as heat at rated load. The drive measures frequency with 12-bit resolution, allowing fine adjustments to motor speed. Its analog output section uses 8-bit resolution for compatibility with legacy transducers. Cable terminals accept power conductors with cross-sectional areas up to 4 mm², while the disconnect accommodates copper conductors with cross-sectional areas up to 6 mm² to support applicable wiring requirements.
The analog output provides a programmable 0/4–20 mA signal for loads with an impedance of up to 500 Ω. Digital outputs can switch up to 40 mA and generate pulses at frequencies up to 32 kHz for high-speed counters. Heat dissipation is limited to 35 W, allowing a small control-cabinet fan to provide sufficient airflow under typical installation conditions. Overcurrent protection is provided by an upstream 10 A fuse. The available analog and digital connections allow the controller to exchange operating commands and status signals with a PLC. The fuse protects the incoming feeder against excessive current, while the stated terminal capacities support properly sized power and disconnect wiring.
