FC-202P90KT6131L7021 Danfoss
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Danfoss FC-202P90KT6131L7021 is a three phase drive from the VLT FC 202 AQUA Drives series with a power rating of 90 kW and a continuous output current of 131 Amps. It provides 125 horsepower and operates with an efficiency of 0.98. The drive supports one analog output with a 500 Ohm load and can handle an estimated power loss of 1800 W.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The FC-202P90KT6131L7021 is a variable-frequency drive produced by Danfoss as part of the VLT FC 202 AQUA Drives series. It accepts three-phase industrial power and supplies a controlled output to centrifugal pumps, blowers, or similar equipment used in fluid-handling systems. By adjusting motor speed rather than using mechanical throttling, the unit supports precise flow regulation and reduces energy demand within automated water and wastewater facilities. Its pump-oriented control functions allow the connected motor to respond to changing flow or pressure requirements without relying entirely on valves or dampers.
This drive delivers a nominal output of 90 kW, equivalent to 125 HP, and can supply a continuous motor current of 131 A. Its internal power section reaches an operating efficiency of 0.98, while the remaining losses amount to 1800 W and must be removed through cabinet ventilation. Upstream circuit protection uses a 250 A prefuse, and the inverter has a three-phase power topology for symmetrical loading of the supply. One analog output is available and supports loads down to 500 Ω, while the single digital output can sink up to 40 mA for status signaling. The control board drives the motor at carrier frequencies up to 32 kHz. It also supports shielded motor cables up to 150 m long or unshielded cables up to 300 m long, allowing the drive to be positioned remotely from motors installed in wet areas.
The unit operates at ambient temperatures up to 50 °C; operation above this temperature requires appropriate derating. Full power is available at elevations up to 1000 m, while controlled derating permits operation at elevations up to 3000 m. A maximum switching frequency of 32 kHz helps reduce audible motor noise in occupied areas. The available cable lengths also provide flexibility when the drive cabinet and motor must be separated by process equipment, access routes, or protected operating zones. Proper ventilation is necessary to remove power losses and maintain suitable internal temperatures during continuous operation. The three-phase input arrangement distributes the electrical load across the supply phases while the controlled output regulates motor speed for changing process demand.
