FC-202P7K5T2131F7536 Danfoss
Wake Industrial LLC is not an authorized distributor of this product.
The Danfoss FC-202P7K5T2131F7536 is part of the VLT FC 202 AQUA Drives series and features a power rating of 7.5 kW, supporting three phase power at a mains voltage of 200 to 240 VAC. This drive delivers a continuous output current of 30.8 A and a maximum output frequency of 590 Hz, with rated efficiency at 0.96. It is designed for applications requiring up to 10 HP and an estimated power loss of 310 W.
Internal Product Review
The FC-202P7K5T2131F7536 is a Danfoss VLT FC 202 AQUA drive designed for 7.5 kW operation on 200 - 240 VAC mains. Three-phase power architecture and 0.96 efficiency give this unit strong operating stability and very good energy performance in pump and water-system service. A 30.8 A continuous output current is a standout specification for consistent load handling.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The FC-202P7K5T2131F7536 is a variable frequency drive manufactured by Danfoss for the VLT FC 202 AQUA Drives series. It regulates centrifugal pumps, blowers, and similar water-handling motors in automated treatment facilities. By adjusting the output frequency supplied to a three-phase induction motor, the unit maintains the required flow or pressure while reducing energy use and mechanical wear. This variable-speed control also allows pump output to follow changes in system demand without relying entirely on throttling valves or other mechanical flow controls.
It accepts a three-phase mains supply of 200 to 240 VAC and delivers a rated shaft power of 7.5 kW to the connected motor. Under continuous load, the inverter provides 30.8 A of output current while drawing 28.0 A, resulting in a continuous apparent power of 11.1 kVA. Its efficiency is rated at 0.96, indicating that only a small portion of the input energy is converted to heat. Analog feedback circuits can support loads up to 500 Ω, digital command inputs tolerate 28 V DC, and transistorized status outputs can source 40 mA. The pulse-width modulation stage can switch at frequencies as high as 32 kHz, providing fine control for acoustic optimization during low-speed operation. The three-phase power stage matches the mains arrangements commonly used for industrial pumping equipment.
For transient events, the inverter can momentarily supply 33.9 A, and its sine-wave modulation supports motor frequencies up to 590 Hz. Start-stop sequencing is limited to two power-ups per minute to protect the DC-link capacitors from excessive electrical stress. Acceleration and deceleration ramps can extend to 3,600 seconds, allowing gradual starts and stops on systems with large hydraulic columns. Upstream protection is coordinated with a 63 A pre-fuse, which helps interrupt excessive current before it damages the drive. Thermal dissipation is represented by an estimated power loss of 310 W at full load. Analog, digital, and transistorized interfaces allow the drive to exchange commands and operating data with external automation controls.
