FC-202P75KT6134F5876 Danfoss
Wake Industrial LLC is not an authorized distributor of this product.
The Danfoss FC-202P75KT6134F5876 is part of the VLT FC 202 AQUA Drives series and supports three-phase power with a normal overload power of 75 kW. It has an efficiency of 0.98 and a maximum output frequency of 590 Hz. The drive can operate at a maximum ambient temperature of 50 °C and supports digital/pulse outputs with a maximum digital output current of 40 mA.
Internal Product Review
The FC-202P75KT6134F5876 is a Danfoss VLT FC 202 AQUA drive built for three-phase power and rated for 75 kW normal overload duty. An efficiency of 0.98 and output frequency up to 590 Hz support strong energy performance and flexible motor control. This drive stands out as a highly capable AQUA solution for demanding industrial pumping applications.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The FC-202P75KT6134F5876 is an AC variable frequency drive engineered by Danfoss for the VLT FC 202 AQUA Drives series. In pump and fan systems, it modulates motor speed to match fluctuating flow demands, reducing energy use and mechanical stress in water and wastewater installations. The drive is optimized for liquid-handling process automation and can regulate motor operation as demand changes. Its variable-speed control is suitable for centrifugal pumps, ventilation equipment, and other applications that benefit from controlled flow or pressure.
It delivers a normal overload rating of 75 kW, allowing centrifugal pumps to absorb short-term load increases without triggering fault shutdowns. Continuous efficiency is 0.98, meaning that two percent of the input power is lost as heat at nominal load. The inverter can provide an output frequency of up to 590 Hz for applications requiring a broad motor-speed range. PWM switching is selectable up to 32 kHz to reduce audible motor noise and improve waveform control. The power terminals accept three-phase power, allowing direct connection to 380–480 V industrial mains. The electronics remain functional at ambient temperatures up to 50 °C; operation above this temperature requires derating to keep internal components within their permitted thermal limits.
Two digital or pulse outputs coordinate status signals, while the analog feedback ports tolerate loads down to 500 Ω without signal distortion. Each digital channel can source up to 40 mA, providing sufficient output for compatible low-current control devices. A line-side pre-fuse rated at 225 A protects the converter against short circuits. Motor leads may use conductors with cross-sectional areas up to 150 mm², while load-sharing cables for common DC links may use conductors up to 95 mm². Shielded motor cable runs are permitted up to 150 m, whereas unshielded motor cable runs may extend to 300 m. The drive can operate without derating at altitudes up to 1000 m. Controlled derating permits operation at sites as high as 3000 m, where reduced air density limits natural heat dissipation from the enclosure.
